Other operations – Sony STR-DB940 User Manual
Page 85
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Operations
Using the auto power function
With the auto power function turned on, the commander
sends numerous codes to the appropriate Sony AV
components when you select a video function
Automatically, the components and the TV you have done
IR setting turn on and the TV switches to the selected
input mode This function works for Sony components
only
1
Press SET UP.
The set up list appears
2
Move the easy scroll key to select "AUTO POWER",
then press the key to enter the selection
The AUTO POWER list appears
Move the easy scroll key to select "BACK LIGHT,"
then press the key to enter the selection
The BACK LIGHT list appears
Move the easy scroll key to select "ON" or "OFF",
then press the key to enter the selection
When you select "ON", move the easy scroll key to
select the video input of the TV, then press the key
to enter the selection
<TU INPUT>
^TU-UIDE01
TU-UIDE02
TU-UIDE03
Note
Switching to VIDEO 1~4 input may not be automatic on all Sony
TVs This is because some TVs cannot receive remote control
codes immediately after being turned on
liurning the backlight on or off
Each time you press a button on the remote, the backlight
turns on If you do the procedure below to turn off the
backlight, you can make the batteries last longer
1
Press SET UP.
The set up list appears
C
HI
5'
(S
3
Move the easy scroll key to select "ON" or "OFF,"
then press the key to enter the selection.
Adjusting the contrast of the display
You can adjust the contrast of the display
1
Press SET UP.
The set up list appears
2
Move the easy scroll key to select "CONTRAST",
then press the key to enter the selection
3
Move the easy scroll key to select"+" or then
press the key to enter the selection
To cancel adjusting
Select "EXIT" in step 3
Clearing all the contents of remote's
memory
Be sure to turn on the receiver and point the remote
towards the receiver when performing the following
procedure
1
Press SET UP.
The set up list appears
2
Move the easy scroll key to select "ALL CLEAR",
then press the key to enter the selection
3
Move the easy scroll key to select "YES", then press
the key to enter the selection
"CLEAR OK?" appears
4
Move the easy scroll key to select "YES" again,
then press the key
All the contents of the remote's memory (i e, all the
programmed data) are cleared
21