Sony STR-DB940 - Manual (Page 86)

Additional
Information
Troubleshooting
If you experience any of fhe following difficulties while
using the remote, use this troubleshooting guide to help
you remedy the problem Should any problem persist,
consult your nearest Sony dealer
The remote does not function.
^ Point the remote at the remote sensor I Î on the
receiver
^ Remove any obstacles in the path between the
remote and the receiver
Replace all the batteries in the remote with new
ones, if they are weak
^ Make sure you select the correct function on the
remote
^ When you operate a programmed non-Sony
component, the remote may not function properly
depending on the model and the make of the
component
The component names appearing in the function
list do not correspond to the jacks on the
receiver./The sound field list does not appear.
^ The remote has not been initialized Turn on the
receiver, point the remote at the receiver, and press
the SOUND FIELD, FUNCTION, or SUB button on
the remote (see page 3)
The SOUND FIELD button does not work
If the receiver has the 5 ICH (/DVD) INPUT jacks,
the SOUND FIELD button becomes inoperable
whenever you select the component connected to
these jacks
cXi appears in the display window of the remote
^ The batteries are running out Replace all the
batteries with new ones
The function names that appear in the display
windows of the receiver and the remote are
different
^ Select the correct function using the remote
When the CD player, tape deck, or MD deck is
connected to the receiver via CONTROL A1/A1 ii
jacks. Auto Function does not work properly.
^ Reprogram the remote (see page 16)
"5 ICH" cannot be selected from the function list
even though the receiver has 5.1CH (/DVD) INPUT
jacks.
^ A communication error has occurred Point the
remote towards the receiver and select "5 ICH"
from the function list again
22