Problems and trouble shooting – Canon E 77 User Manual
Page 61
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
58
Problems and Trouble Shooting
Use the following checklist for trouble shooting when you have problems with your camera. Consult your
local dealer or service outlet if problems persist.
Be sure all connections are properly made when using the camera with other units.
Camera does not turn on.
Battery Pack charge is low.
Replace with a fully charged
Battery Pack.
Camera turns off during
operation.
Battery Pack charge Is low.
Replace with fully charged
Battery Pack.
Record pause mode has lasted
for more than seven minutes.
Turn camera on again.
Video cassette compartment
does not open.
Power source not connected.
Connect power source.
Battery Pack charge Is low.
Replace with fully charged
Battery Pack.
Camera is off.
Turn camera on.
Camera does not function when
an operation button is pressed.
Battery Pack charge is low.
Replace with fully charged
Battery Pack.
Video cassette not loaded.
Load a video cassette.
OPERATE/CAUTION indicator
flashes and “ВАТТ” flashes in
viewfinder.
Battery Pack charge is low.
Replace with fully charged
Battery Pack.
OPERATE/CAUTION indicator
flashes and "DEW” flashes in
viewfinder.
Condensation (Dew) has formed
inside unit.
Refer to “Condensation”
(see p.60).
OPERATE/CAUTION indicator
flashes.
An operating error has activated
the safety mechanism.
Unload and reload video
cassette.
“E” appears in viewfinder.
Lithium battery not in place
properly or charge is low.
Insert new lithium battery
(see p.13).
Camera is off.
Turn camera on.
Video cassette not loaded.
Load a video cassette.
START/STOP button is pressed,
but recording does not start.
Tape has ended (“T.END”
appears in viewfinder).
Rewind tape or use another
video cassette.
Erasure prevention switch on
the video cassette is set to
prevent recording.
Use another video cassette or
set switch to enable recording
(see p.19).
The camera is in stop mode.
Turn camera off then on again.
No picture appears in
Image invert switch not properly
set to NORM or ANGLE
FINDER.
Set Image invert switch properly
to either NORM or ANGLE
FINDER.
viev^inder.
Lens cap Is still attached to
camera.
Remove lens cap.
Camera will not start playback
from stop mode.
Built-in safety mechanism is
operating.
Turn camera off and remove
video cassette. Wait 10 seconds
and try again.