EFCO 960 Series - Manual (Page 45)

Cover the heads of all
attachment screws with sealant.
located in the opening of the back member.
The flashing attachment screws are
When corners are required,
miter the flashing to the
required angle and install
as shown in Fig. # 36 and # 37.
SILL FLASHINGS AVAILABLE:
9972 - 1 9/16" B.M.
9982 - 2 9/16" B.M.
9668 - 4 1/16" B.M.
9974 - 4 13/16" B.M.
FIG. # 37
3"
TYP.
FIG. # 36
TYP.
3"
9972
The flashing attachment screws are
located in the opening of the back member.
attachment screws with sealant.
SEALANT
Cover the heads of all
9982
SEALANT
PAGE 43
(cont.)
JDA 6/2002
SECTION VII - SILL FLASHING INSTALLATION
960 WALL
sill perimeter fastener to ensure
flashing is sealed.
that the hole through the sill
force sealant into the hole for the
Before the fastener is inserted,