EFCO 960 Series - Manual (Page 46)

and the sealant must tie in with the jamb blocking
Incorporating the sill flashing end caps will complement
The end caps must be sealed to the condition
The end cap edges must also be concealed with the sealant
This may cause the caulk joint at the jamb to increase in thickness,
and the perimeter seals.
to present a neat and clean installation.
if the condition is irregular.
the sealing procedure.
Fig. # 38
JDA 10/2000
END CAP to BACK MEMBER
FOR THE CORRECT
REFER TO PAGE 13
COMBINATION
END CAP ATTACHMENT
SILL FLASHING INSTALLATION
VIEW AT JAMB AND CONDITION
PERIMETER MEMBER
SECTION VII -
(CONT.)
PAGE 44
SILL MEMBER
TYPICAL
TYPICAL
VERTICAL
TYPICAL
INTERMEDIATE
SEALANT
SEALANT
The sill flashing must be sealed to the
condition and the jamb member set in
a bead of sealant to ensure a water
tight seal.