Temporary glazing, Glazing, Fig. # 69 – EFCO 960 Series User Manual
Page 64: Using clips & covers

If temporary glazing is required, EFCO recommends the use of (2) 12" lengths
every corner of each daylight opening resulting in 8 pieces of snap cover per
full length covers can be installed. This temporary clipping should be installed at
full length covers and the required quantity of clips have been installed.
a structural application. This system will not meet structural performances until
daylight opening. This is a temporary application only and is not to be used for
of the snap cover and (3) clips min. per cover piece, snapped in place as shown
above, at the corners of the horizontals and verticals to retain the glass until the
JDA 3/2002
& (3) ISOLATOR CLIPS PER COVER
(2) 12" COVERS w/ BULB GASKET
HORIZONTALLY & VERTICALLY
NOTE:
DUAL CLIP
9"
12"
SINGLE CLIP
TYP. TO
FIG. # 69
3"
CL
CLIP 3"
DUAL
L
C
TYP. APPLICATION SHOWING
TEMPORARY COVER
LOCATIONS
D.L.O.
TYP. TO
SINGLE CLIP
12"
6"
D.L.O.
SECTION X B - TEMPORARY
D.L.O.
USING CLIPS & COVERS
D.L.O.
GLAZING
PAGE 62
960 WALL