EFCO 960 Series - Manual (Page 57)

gasket into the sealant. Refer to the figures below.
Apply sealant in the glazing bulb cavity 1" from the ends, and push the bulb
(D.C. 795)
SILICONE TYPE SEALANT
Push in all VERTICAL glazing gasket, being careful not to stretch the gasket.
STEP 1)
FIG. # 60
horizontals and verticals.
1" from the ends of all
Set bulb in sealant
FIG. # 58
1"
TYP.
the gasket.
Push the bulb
in being careful
not to strech
PAGE 55
JDA 10/2000
SECTION VIII G -
SCREW SPLINE / SHEAR BLOCK
BULB GASKET INSTALLATION
Push in all HORIZONTAL glazing gasket, being careful not to stretch the gasket.
Apply sealant in the glazing bulb cavity 1" from the ends, and push the bulb
gasket into the sealant. Refer to the figures above.
STEP 1)
GASKET SHOWN
INSTALLED