ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) - Manual (Page 14)

Assembly Instructions MODEL 2065 LOPRO TURNTABLE
10 © EMC TEST SYSTEMS, L.P. – APRIL 2002
REV F – PN 399230
ASSEMBLY INSTRUCTIONS
CAUTION Ensure power is OFF and secured before proceeding
further.
1) Position the turntable mechanical assembly on the floor. The
turntable mechanical assembly has a 44 inch (112 cm) wide
base plate that needs to rest on a flat surface. To insure proper
alignment of the drive shaft, the bottom surface of all three sub
assemblies: the TT mechanical assembly, the drive shaft
assembly and the motor drive will need to be installed at the
same level with each other. It may be necessary to place shims
under the base if the floor is not flat. The table base plate has
four holes for fastening the unit to the floor using 5/16"
diameter screws but will stay in place due to its own weight.
2) After the turntable is in position, remove the plastic gear box
cover plate by loosening the 4 plastic bolts used to hold it in
place.
If the optional shaft kit was purchased please continue to the
Optional Shaft Kit Installation Instructions and disregard the
remainder of the instructions in this section.
3) Install the aluminum shaft adapter to the black shaft out of the
turntable gearbox. A ¼” phenolic (brown plastic) pin is used
to key it to the black shaft. A spacer piece fits inside the shaft
adapter, between the adapter and the pin to help secure the pin
in place. Two setscrews (size 8-32) lock the adapter in place on
the shaft.
4) The gray hose coupling with two hose clamps around it is now
slipped on to the shaft adapter.
5) The motor drive is held to the turntable base by an aluminum
bracket. The bracket attaches to the ¾” base plate of the
turntable using two ½-13 x ¾” bolts. There are two standoffs
that attach the bracket to the motor base at the correct distance.
Archived 3/18/10