ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) - Manual (Page 32)

Recommended Maintenance MODEL 2065 LOPRO TURNTABLE
28 © EMC TEST SYSTEMS, L.P. – APRIL 2002
REV F – PN 399230
RECOMMENDED MAINTENANCE
Regular maintenance and inspection will prolong the serviceability
of your turntable. Follow this recommended schedule.
CAUTION: Do not perform maintenance while the turntable is
operating.
MONTHLY
Inspect the turntable assembly for loose fasteners, abnormal wear
and oil leaks.
Verify the accuracy of the current position setting on the controller
in relation to the turntable. The stopped position of the turntable
platform at 0 degrees may drift over time depending un usage. See
the sections “Setting Current Position on 2090” and “Caution: On
Resetting Current Position on 2090” for more information about
this procedure.
SEMI-ANNUALLY
Check all parts for wear.
The drive belt if furnished fully tensioned on new units. After
usage the belt may need to be tightened. (Refer to drawing 5 in the
back of the manual.) To take up any slack in the belt, loosen the 6
bolts on the gearbox, move it outward and retighten.
ANNUALLY
1. Grease the plastic miter gears. A silicone grease lubricant is
recommended.
2. Clean the bearing races to remove any dust or dirt that may
have accumulated. (see instructions below for this procedure)
3. Thoroughly inspect the unit for wear.
Archived 3/18/10