ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) - Manual (Page 16)

Optional Shaft Kit Installation Instructions MODEL 2065 LOPRO TURNTABLE
12 © EMC TEST SYSTEMS, L.P. – APRIL 2002
REV F – PN 399230
OPTIONAL SHAFT KIT INSTALLATION
INSTRUCTIONS
The Optional Shaft Kit allows the motor base to be positioned up
to 5 meters (16.4 ft) away from the turntable. If the optional shaft
kit was not purchased as part of this installation please continue to
the “OPERATION” section.
The optional drive shaft assembly consists of an inner shaft
mounted in an outer housing that is supported in the center and at
each end by plastic floor supports. The instructions that follow
provide guidance through the assembly process for the shaft as
well as instructions for cutting the shaft components if a shorter
distance between the motorbase and turntable is required.
WHAT IS INCLUDED IN SHIPMENT
Item Quantity
Shaft Sections 2 ea.
Shaft Coupler 1 ea.
¼-20 Self Tapping Screws 4 ea.
End Floor Supports –these have a single clamp for a
single item 2 ea.
Mid Floor Support – this has a double clamp for
two items 1 ea.
Shaft Housings, 4.5 inches DIA 2 ea.
White Bushings – one will go at each end of the
shaft housing assembly and one will go in the
center between the two shaft housing components. 3 ea.
Archived 3/18/10