ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) - Manual (Page 17)

MODEL 2065 LOPRO TURNTABLE Optional Shaft Kit Installation Instructions
© EMC TEST SYSTEMS, L.P. – APRIL 2002 13
REV F – PN 399230
TOOLS REQUIRED
In addition to the tools required for basic installation:
Tape Measure
Drill
Assorted Bits including 7/32
Hand or Reciprocating Saw
Marker
File and or Sandpaper
DETERMINING THE LENGTH OF THE SHAFT
In order to install the shaft kit the customer needs to determine the
dimensions DIM1 as shown on Drawing 4 in the back of the
manual. This is the distance from the center of the turntable top to
the end of the drive shaft floor support.
If DIM1 needs to be shorter than the standard 5 m (16ft 5 inches),
then the drive shaft assembly needs to be cut to the proper lengths
before attaching it to the turntable. Refer to the section “CUTTING
THE DRIVE SHAFT ASSEMBLY” for instructions on cutting the
shaft if a shorter length is required. Follow these instructions
before continuing. No cutting is required if the standard length
above is acceptable for installation.
The shaft must be the correct length before proceeding.
DRIVE SHAFT ASSEMBLY
To assemble the two sections of the drive shaft (A and B as shown
in Drawing 8) using the coupling provided. Insert the 6.0 cm (2.37
in) diameter plain ends of the shaft sections into the coupling all
the way to the step. Match drill the shaft sections through four pre-
drilled holes in the coupling and install the four ¼-20 self tapping
screws provided.
Archived 3/18/10