ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) - Manual (Page 7)

MODEL 2065 LOPRO TURNTABLE Model 2065 Options
© EMC TEST SYSTEMS, L.P. – APRIL 2002 3
REV F – PN 399230
MODEL 2065 OPTIONS
Model 2090 Positioning Controller: This controller provides
control for two separate devices (towers and turntables) in any
combination, plus the control of four auxiliary devices via a fiber
optic interface. The unit includes a GPIB connection and is
compatible with most popular EMI measurement software.
Hand Control Unit: This sturdy, hand-held controller will allow
the user to manually operate the table remotely and independently
from the Model 2090 Positioning Controller. This controller
attaches conveniently to the Motor Base Unit of the Model 2065
Low Profile Turntable. Functions include: Clockwise (CW),
Counterclockwise (CCW) and Hand/Main Control selection.
Shield Room Feed-through: This option allows the customer to
take the fiber optic control cable from the control room to the
shield room while maintaining shielding attenuation. The unit is
made of brass for conductivity and provides attenuation of greater
than 100 dB at 10 GHz. A single 22.25 mm (.875 inch) hole is
required to mount this option.
Additional Fiber Optic Cable: Various lengths of fiber optic
cable are available by custom order. The standard length provided
is 10 m (32.8 ft).
Shaft Kit (Optional): This option allows the user to position the
electric drive motor farther away from the turntable. The
extension shaft separates the turntable and the drive motor by as
much as 5 m (16.4ft). Following the detailed instructions in this
manual, it may be cut to a custom length. This option must be
specified at the time the order is placed.
Archived 3/18/10