ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) - Manual (Page 22)

Optional Shaft Kit Installation Instructions MODEL 2065 LOPRO TURNTABLE
18 © EMC TEST SYSTEMS, L.P. – APRIL 2002
REV F – PN 399230
This will make the coupling offset 3 inches from the center
after it is assembled.
NOTE: Be sure to measure and mark each section from the small
end (NOT THE PLAIN END). The length of section A (on the
turntable side) should be at least 150mm (6 inches) longer than the
other section B (on the motor side).
6. Place the shaft sections side by side to double check the length
from small end to small end. Offset the cut marks 6.35mm (.25
inch) for the coupling. If the length is okay then cut the shaft
pieces to length at the marks.
7. De-burr the cut ends before installing them in the coupling.
8. Install the plain end of each shaft into the coupling all the way
to the step. The total overall length should be close to the
length calculated in step 3.
CUTTING THE SHAFT HOUSING
9. The shaft housing(s) need to be cut next:
a. If DIM1 in step1 was 3035mm (9ft 11.5inches) or less
then the middle floor support IS NOT required – only
one housing will be used. Continue to step 10.
b. If DIM1 is more than 3035 mm (9ft 11.5inches) then
the middle floor support will be required – two
housings will be used. Continue to step 11.
10. Determine the total length of the shaft housing. Only one
housing will be used. Subtract 4.75 inches from the overall
length of the assembled shaft in step 3. Then cut one of the two
housings to this length +/– 1/16 inch. Discard the other unused
housing and mid floor support. Skip to step 12.
11. Determine the total combined length of the two shaft housings.
Both housings will be used along with the middle floor
support. Subtract 5.75 inches from the overall length of the
assembled shaft to get the combined length of the housings.
Cut each housing to one half this length +/- 1/16 inch. After
Archived 3/18/10