ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) User Manual
Page 33
MODEL 2065 LOPRO TURNTABLE
Recommended Maintenance
© EMC TEST SYSTEMS, L.P. – APRIL 2002
29
REV F – PN 399230
Cleaning the bearing races
To clean the bearing races the turntable top will need to be
removed.
1. Remove the 8 bolts at the center ring in order to remove the
center plate/flange that holds the turntable down.
2. If the keepers are in place holding the turntable top down at the
four corners of the assembly remove the bolts that hold the 4
keepers in place and the keepers at the same time.
3. Gently lift the turntable top and place it to the side. The bearing
races will now be exposed.
4. Remove the bearings and carefully place them into a container
for safe storage so as not to loose any.
5. Use a clean, damp rag; moistened with water to clean the races.
No lubrication is necessary in the tracks.
6. When you are through cleaning, replace the bearings in the
tracks. Alternate the delrin and nylon bearings to improve wear
characteristics. The delrin bearings are white while the nylon
bearings have a tan tint to them. Gently replace the turntable
surface to its original location. Insert the plate/flange in the
center and the 8 bolts that hold it in place. If desired reinstall
the four keepers at the edge of the turntable surface.
Archived 3/18/10