ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) User Manual
Page 20
Optional Shaft Kit Installation Instructions
MODEL 2065 LOPRO TURNTABLE
16
© EMC TEST SYSTEMS, L.P. – APRIL 2002
REV F – PN 399230
tie bracket in place and installe one hose clamp onto the steel drive
shaft and one onto the plastic shaft.
The floor supports and motor drive unit can now be fastened to the
floor using 5/16 inch diameter screws through the mounting holes
in the bottom base of the shaft supports and motor drive.
Reinstall the gearbox cover using four 3/8-16 x 1 inch hex screws.
Be careful not to over-tighten these plastic bolts.
If desired cables can be run along a slot under the base of the
turntable up through the opening at the center of the table. The slot
is 1 cm (.40 in) deep and 2.54 cm (1 in) wide. It should accept a
cable as large as 3/8 inch diameter.
Archived 3/18/10