ETS-Lindgren 2065 LoPro Turntable Electric-powered 1.2m Turntable (Archived) - Manual (Page 8)

Precautions MODEL 2065 LOPRO TURNTABLE
4 © EMC TEST SYSTEMS, L.P. – APRIL 2002
REV F – PN 399230
PRECAUTIONS
Read this manual completely before starting installation. This
equipment should be installed and operated only by qualified
personnel.
Ensure correct voltage setting is selected on the Motor Base Unit.
Do not attempt to service unless qualified to do so. As with any
electrical equipment, ensure that electrical power to the unit has
been disconnected and secured when performing scheduled
maintenance or adjustments.
Do not make any modifications to this unit without consulting the
factory directly.
Stay clear of all moving components on this equipment.
Do not operate this equipment with the protective covers removed.
Do not, at any time, place hands or feet in the vicinity of the drive
gears on the turntable.
Do not operate the turntable while someone is physically on the
turntable top.
Regularly inspect the equipment for loose fasteners and wear.
Conduct appropriate scheduled maintenance in accordance with
factory recommendations.
Only use replacement parts and fasteners ordered directly from the
factory.
The fiber optic cable must be looped through the “P” clip installed
on the front panel of the motor base. Failure to do so will increase
the chance of the cable being accidentally pulled, thus breaking the
fiber optic connectors.
WARRANTY
Archived 3/18/10