Cisco WIRELESS ACCESS POINT WAP4410N - Manual (Page 14)

Getting to Know the Wireless-N Access Point
Back Panel
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide 14
3
Back Panel
The back panel of the device consists of:
• RESET Button—There are two ways to reset the access point to the
factory default configuration. Either press the Reset button for
approximately 10 seconds or restore the defaults using the web-based
utility of the access point.
• ETHERNET Port—Connects to Ethernet network devices, such as a switch
or router.
• POWER Port—Connects the access point to power using the supplied
12VDC power adapter. Use if your switch or router does not support PoE.
Antennas and Positions
The Cisco WAP4410N Access Point has three detachable 2dBi omni-directional
antennas. These antennas are located on the back of the device.
The three antennas have a base that can rotate 90 degrees when in the standing
position. The three antennas support 3X3 “multiple in, multiple out” (MIMO)
diversity in wireless-N mode.