Cisco WIRELESS ACCESS POINT WAP4410N User Manual
Page 34
Configuring the Cisco WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide
34
6
Configuring WPA2-Enterprise
The WPA2-Enterprise mode features WPA2 used in coordination with a RADIUS
server for client authentication.
!
CAUTION
Use this mode only when a RADIUS server is connected to the access point.
To enable wireless WPA2-Enterprise security, follow these steps:
STEP 1
Click Wireless > Security.
STEP 2
From the Security Mode drop-down menu, select WPA2-Enterprise.
STEP 3
To enable wireless isolation within the SSID, click Enabled.
STEP 4
Provide the following information:
•
Primary/Backup RADIUS Server—Enter the IP address of the RADIUS
server. The Backup Radius server is used only if the primary server is
unavailable.
•
Primary/Backup RADIUS Server Port—Enter the port number used by
the RADIUS server. The default is 1812. The backup Radius server is used
only if the primary server is unavailable.
•
Primary/Backup Shared Secret—Enter the Shared Secret key used by the
access point and RADIUS server. The backup Radius server is used only if
the primary server is unavailable.
•
WPA Algorithms—WPA2 always uses AES for data encryption.
•
Key Renewal Timeout—Enter a key renewal timeout period, which
instructs the access point how often it should change the encryption keys.
The default is 3600 seconds.
STEP 5
Click Save.