Cisco WIRELESS ACCESS POINT WAP4410N User Manual
Page 36
Configuring the Cisco WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide
36
6
Configuring RADIUS
This option features a RADIUS server for client authentication.
!
CAUTION Use this mode only when a RADIUS server is connected to the access point.
To enable wireless Remote Authentication Dial-In User Service (RADIUS) security,
follow these steps:
STEP 1
Click Wireless > Security.
STEP 2
From the Security Mode drop-down menu, select RADIUS.
STEP 3
To enable wireless isolation within the SSID, click Enabled.
STEP 4
Provide the following information:
•
Primary/Backup RADIUS Server—Enter the IP address of the RADIUS
server. The Backup Radius server is used only if the primary server is
unavailable.
•
Primary/Backup RADIUS Server Port—Enter the port number used by
the RADIUS server. The default is 1812. The backup Radius server is used
only if the primary server is unavailable.
•
Primary/Backup Shared Secret—Enter the Shared Secret key used by the
access point and RADIUS server. The backup Radius server is used only if
the primary server is unavailable.
STEP 5
Click Save.
Configuring WEP
This security mode is defined in the original IEEE 802.11. This mode is not
recommended now due to its weak security protection. For better security,
migrate to WPA or WPA2.