Cisco WIRELESS ACCESS POINT WAP4410N - Manual (Page 25)

Configuring the Cisco WAP4410N Wireless-N Access Point
Setup
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide 25
6
STEP 1 Click Setup > Basic Setup.
STEP 2 From the IP Settings drop-down menu, select one of the following options:
• Static IP Address—Select this option to assign a static or fixed IP address
to the access point.
• Automatic Configuration—Select this option to automatically configure
the IPv4 network settings of the access point using a DHCP server on your
network. Also select this option to automatically configure the IPv6 network
settings of the access point using an IPv6 RADVD device enabled on your
network.
STEP 3 If you select Static IP Address from the IP Settings drop-down menu, enter the
following information in the IPv4 section of the screen:
• Local IP Address—Enter a unique IP address for your access point. The
default IP address is 192.168.1.245.
• Subnet Mask—Enter the same subnet mask used in your network. The
default is 255.255.255.0.
• Default Gateway—Enter the IP address of your Gateway or Router. Enter
the value used by other devices on your LAN.
• Primary DNS—Enter the IP address of your primary DNS server.
• Secondary DNS—Enter the IP address of your secondary DNS server.
STEP 4 To configure the IPv6 settings for your access point:
• IPv6—Select Enabled to enable IPv6 for your access point.
• Accept Router Advertisement—Check this check box to accept router
advertisement.
• Local IP Address—Enter a unique IP address for your access point.
• Default Gateway—Enter the IP address of your gateway or router. This
address is used by the other devices on your network.
• Primary DNS—Enter the IP address of your primary DNS server.
• Secondary DNS—Enter the IP address of your secondary DNS server.
STEP 5 Click Save.