Cisco WIRELESS ACCESS POINT WAP4410N - Manual (Page 21)

Setting Up the Cisco WAP4410N Wireless-N Access Point
Navigating the Utility
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide 21
5
Setup
This page allows you to configure the host name and IP address settings and to
set the time.
• Basic Setup —Configures the host name and IP address settings for this
access point.
• Time —Sets the time on this access point.
• Advanced —Sets the HTTP Redirect and 802.1x supplicant settings for this
access point.
Wireless
This page allows you to enter a variety of wireless settings for the access point.
• Basic Settings —Configures the wireless network mode (for example, B/G/
N-Mixed), SSID, and radio channel.
• Security —Configures the access point’s security settings.
• Connection Control —Controls the wireless connections from client
devices to this access point.
• Wi-Fi Protected Setup —Simplifies the process of setting up and
configuring security on a wireless network.
• VLAN and QoS —Configures the 802.1Q VLAN and the Quality of Service
(QoS) settings.
• Advanced Settings —Configures the access point’s more advanced
wireless settings (for example, load balancing and channel bandwidth).
AP Mode
This page allows you to select the mode of operation for the access point. The
default mode is Access Point.
Administration
This page allows you to manage the access point.
• Management —Configures the password and Simple Network
Management Protocol (SNMP) settings.