Factory default, Firmware upgrade – Cisco WIRELESS ACCESS POINT WAP4410N User Manual
Page 48
Configuring the Cisco WAP4410N Wireless-N Access Point
Administration
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide
48
6
Factory Default
The Administration > Factory Default page allows you to restore the access
point’s factory default settings. Note any custom settings before you restore the
factory defaults. Once the access point is reset, you will have to re-enter all of your
configuration settings.
STEP 1
Click Administration > Factory Default.
STEP 2
Click Yes to restore the factory default settings.
STEP 3
Click Save. Your access point will reboot.
Firmware Upgrade
The Administration > Firmware Upgrade page allows you to upgrade the access
point’s firmware.
!
CAUTION
Do not upgrade the firmware unless you are experiencing problems with the
access point or the new firmware has a feature you want to use.
!
CAUTION
Upgrading the firmware deletes all custom settings.
To upgrade the firmware of the access point, follow these steps:
STEP 1
Back up the configuration settings of your access points (see
STEP 2
Upgrade the access point’s firmware:
a. Download the firmware upgrade file from:
b. Extract the firmware upgrade file.
c. Click Administration > Firmware Upgrade.