Cisco WIRELESS ACCESS POINT WAP4410N - Manual (Page 30)

Configuring the Cisco WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide 30
6
Security
The Wireless > Security page displays the wireless security settings of the
access point. To configure the wireless security settings of the access point,
follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 To configure wireless isolation between SSIDs:
a. From the Select SSID drop-down menu select an SSID.
b. To isolate wireless clients from each other, click Enabled. Otherwise, click
Disabled.
STEP 3 To disable wireless security completely, from the Security Modes drop-down,
select Disabled. Disabled is the default setting.
STEP 4 To enable wireless security, from the Security Mode drop-down menu, select one
of the following security modes and provide the required information, as
described in the sections below.
• WPA-Personal
• WPA2-Personal
• WPA2-Personal Mixed
• WPA-Enterprise
• WPA2-Enterprise
• WPA2-Enterprise Mixed
• Radius
• WEP
STEP 5 To prevent wireless computers associated to the same SSID from seeing and
transferring files between each other, in the Wireless Isolation (within SSID) field,
click Enabled.
This feature is very useful when setting up a wireless hotspot location. The default
is Disabled.
STEP 6 Click Save.