Cisco WIRELESS ACCESS POINT WAP4410N - Manual (Page 26)

Configuring the Cisco WAP4410N Wireless-N Access Point
Setup
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide 26
6
Time
The Setup > Time page displays the time settings of the access point. By setting
up the correct time, you can help your network administrator search the system
log to identify problems. By default, the WAP is configured to obtain its time from a
predefined list of NTP servers.
To otherwise configure the time settings for the access point, follow these steps:
STEP 1 Click Setup > Time.
STEP 2 To manually configure the time settings:
a. Select Manually.
b. Enter the date and the time.
STEP 3 To automatically configure the time settings to obtain the time from a time server
on your network or on the Internet:
a. Select Automatically.
b. From the Time Zone drop-down menu, select a time zone.
c. If appropriate, check the Automatically adjust clock for Daylight Saving
changes check box.
STEP 4 To set up local NTP server, enable the User Defined NTP Server option. Default is
Disabled.
• NTP Server IP—Enter the IP address of user-defined NTP Server.
STEP 5 Click Save.