Cisco WIRELESS ACCESS POINT WAP4410N - Manual (Page 50)

Configuring the Cisco WAP4410N Wireless-N Access Point
Status
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide 50
6
SSL Certification Management
To generate the certificate with the WAP device, click Export Certificate.
Generating a new SSL certificate restarts the secure Web server. The secure
connection will not work until the new certificate is accepted on the browser.
If an SSL certificate (with a .pem extension) exists on the WAP device, you can
install it to your computer as a backup. Browse to the certificate file and click
Install Certificate.
Status
The Status section describes how to change the status settings for the access
point:
Local Network
The Status > Local Network page displays the access point’s current status
information for the local network. To check local network status, follow these
steps:
STEP 1 Click Status > Local Network.
This page displays the status information of your access point:
- PID VID—The WAP hardware model and version.
- Software Version—The version of the access point’s current software.
- Local MAC Address—The MAC address of the access point’s local
network interface.
- System Up Time—The length of time the access point has been
running.
• Local Network
- IP Address—The access point’s IP address as it appears on your local
network.
- Subnet Mask—The access point’s subnet mask.
- Default Gateway—The IP address of your gateway or router. The value
used by other devices on your LAN.