Mercedes-Benz G-Class 2015 - Manual (Page 269)

Important safety notes
G WARNING
When you operate or program the garage door
with the integrated garage door opener, per-
sons in the range of movement of the garage
door can become trapped or struck by the
garage door. There is a risk of injury.
When using the integrated garage door
opener, always make sure that nobody is
within the range of movement of the garage
door.
G WARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases leads to poisoning. There
is a risk of fatal injury. Therefore never leave
the engine running in enclosed spaces with-
out sufficient ventilation.
When programming a garage door opener,
park the vehicle outside the garage. Do not
run the engine while programming.
Programming the remote control
Programming
Pay attention to the "Important safety notes"
(
Y
page 267).
Integrated remote control in the rear-view mirror
:
Indicator lamp
; = ? Transmitter buttons
A Garage door remote control
B Transmitter button on the garage
door remote control
Garage door remote control A is not part of
the garage door opener.
i To achieve the best result, insert new bat-
teries in garage door remote control A of
your garage door drive before program-
ming.
X
Delete the memory of the integrated
remote control (
Y
page 270) before pro-
gramming it for the first time.
X Turn the SmartKey to position 2 in the igni-
tion lock (
Y
page 133).
X
Press and hold transmitter button ;, =
or ?.
After a short time, indicator lamp : will
start flashing. It flashes approximately
once per second.
i Indicator lamp : flashes immediately
the first time that the transmitter button is
programmed. If this transmitter button has
already been programmed, indicator
lamp : will only start flashing at a rate of
once a second after 20 seconds have
elapsed.
X Continue to hold the transmitter button.
X Point transmitter button B of garage door
remote control A towards the transmitter
buttons on the rear-view mirror at a dis-
tance of 2 to 12 inches (5 to 30 cm).
i The distance between garage door
remote control A and the integrated
garage door opener depends on the system
of the garage door drive. Several attempts
might be necessary. You should test every
position for at least 20 seconds before try-
ing another position.
X Keep transmitter button B on garage door
remote control A pressed until indicator
lamp : starts to flash rapidly.
The programming has been successful if
indicator lamp : flashes rapidly.
X
Release transmitter buttons ;, = or ?
on the integrated remote control and trans-
mitter button B on the garage door remote
control.
Features
267
Stowage
and
features
Z