7285q 86_2012.7.5pdf_42, Straight stitching – SINGER 7285Q PATCHWORK Instruction Manual User Manual

Page 44

Advertising
background image

42

STRAIGHT STITCHING

Straight stitch is most frequently used for all types of sewing.
Let’s begin by following the steps below.

1. SETTINGS

Presser foot - General Purpose Foot

Thread tension control - AUTO

A. Thread tension control
B. Reverse stitch button
C. Programmable needle up/down button
D. Start/stop button
E. Presser foot lifter
F. Sewing speed control

2. Pull both threads under the presser foot toward the back of

the machine, leaving about 6” (15cm) clear.

3. Place the fabric under the presser foot and lower the

presser foot lifter.

4. Turn the hand wheel toward you (counter-clockwise) until

the needle enters the fabric.

5. Start the machine. Guide the fabric gently with your hands.

When reaching the edge of the material, stop the sewing
machine.

6. First turn the handwheel toward you (counter-clockwise)

until the needle is at its highest position. Raise the presser
foot, draw materials to the rear and cut off excess thread
with the thread cutter located on the bottom of face cover
as shown.

.((3,1*6($06675$,*+7

To keep the seam straight, use one of the numbered guide
lines on the needle plate. The numbers indicate distance from
the needle at its center position.

The guide line on the bobbin cover plate is 1/4" (6mm) seam
guide line which is used for piecing quilt blocks and also for
narrow seams.

NOTE: T o secure the stitching and avoid raveling,

press the reverse stitch switch and sew a few

stitches at the start and end of the seam.

NOTE: The Needle Plate has both Metric and Inch

Markings as an aid for guiding your fabric when

sewing a seam.

NOTE: Based upon the weight of the fabric, slight

³¿

ne tuning´ of the tension may be desired.

E

F

A

B

C

D

1

6

5

2

3

4

3/4" (19 mm)

5/8" (16 mm)

1/2" (13 mm)

3/8" ( 9 mm)

1/4" ( 6 mm)

Advertising
This manual is related to the following products: