SINGER S18 STUDIO Instruction Manual - Manual (Page 12)

12
Changing the Presser Foot
Many of the various presser feet can be changed easily
with a push of the finger.
To snap off foot:
Raise the needle and presser foot to the up position.
Press the button on the back of the presser foot holder
and the foot will drop.
1 Button
2 Foot holder
3 Presser foot
To snap on:
Align the presser foot so the pin on the foot lies just
under the groove of the presser foot holder.
Lower the presser foot holder to lock the foot in place.
Each foot is marked with a letter for identification.
4 Groove
5 Pin
6 Identification letter
CAUTION
When selecting the proper foot for the stitch pattern
selected, refer to the information in the LCD window.
Also the help button can help you chose the right foot
for the right sewing technique. See page 25 in the
manual for further information.
Remember that not all stitches can be sewn with all
of the feet. Be careful because the incorrect foot can
cause needle damage and harm to your machine.
Removing and Attaching the Presser Foot
Holder
WARNING
Turn OFF the power switch before detaching or
attaching the presser foot holder.
To detach:
Raise the presser foot holder up. With large screwdriver
turn the thumbscrew counterclockwise to remove the
presser foot holder from the needle bar.
1 Thumbscrew
2 Presser foot holder
To attach:
Align the hole in the presser foot holder with the
threaded hole in the presser bar and insert the
thumbscrew through the hole.
Tighten the thumbscrew by turning it clockwise.
3 Presser bar
1
2
3
4
5
1
2
1
2
3
6