SINGER S18 STUDIO Instruction Manual - Manual (Page 14)

14
Winding the Bobbin
Removing the bobbin
Slide the bobbin case cover plate release button to the
right and remove the bobbin case cover plate.
Lift out the bobbin from the bobbin case.
1 Bobbin case cover plate release button
2 Bobbin case cover plate
3 Bobbin
NOTE
Use only SINGER
® Class 15 bobbins in your machine.
Using improper sized bobbins and pre-wound bobbins
may cause stitching problems. Improper bobbins can
damage your bobbin case and machine.
Preparing the Thread Spool for Winding
Place the spool of thread on the spool pin with the
thread coming off the spool as shown. Attach the spool
cap and press it snug against the spool of thread.
1 Spool of thread
2 Spool pin
3 Spool holder
A spool cap is used to prevent the spool moving as
the thread feeds off. The cap also prevents thread
catching on rough edges at the top of the spool. The
automatic thread cutter works best when threads are
held stationary with spool caps.
Use the large spool cap for large spools and the small
spool cap for small spools.
4 Small spool
5 Small spool cap
NOTE
When sewing with decorative threads wound on paper
spool spools the automatic thread cutter should not
be used. The spool caps may not hold the spool from
moving when the cutter activates. The movement can
cause the threads to drop down from the spool. The
pooling at the bottom of the spool will cause the thread
to not feed off correctly.
1
2
3
1
2
3
3
1 4 4
5 5
Go to www.singerco.com for information on
where to buy needles and bobbins.