SINGER S18 STUDIO Instruction Manual User Manual

Page 16

Advertising
background image

16

Inserting the Bobbin

Step 1
Place the bobbin in the bobbin case with the
thread coming off counter clockwise.

1 Thread

2 Bobbin case

Step 2
Guide the thread into notch

(A) on the front

of the bobbin case.

Step 3
Draw the thread to the left, sliding it between the
tension spring blades.

Step 4
Continue to draw the thread lightly until the
thread slips into side notch

(B). The bobbin

should turn counter clockwise when pulling the
bobbin thread.

Step 5
Pull out about 4” (10 cm) of thread to the rear.
Refer to the threading chart shown on the bobbin
case cover plate.
Reattach the bobbin case cover plate.

3 Threading diagram

5

3

1

2

(A)

2

3

(B)

4

(B)

1

Advertising
This manual is related to the following products: