SINGER S18 STUDIO Instruction Manual - Manual (Page 45)

45
Step 3
Pull the buttonhole lever down as far as it will go.
1 Buttonhole lever
NOTE
If you start sewing without pulling down the buttonhole
lever, the LCD screen will display a message, the machine
will sound a warning and sewing will stop after a few
stitches. Pull the buttonhole lever down and continue
sewing.
2 LCD screen warning
Step 4
Place a scrap piece of the fabric under the foot. Press
the needle up/down button twice.
Remove the scrap to the left to draw the needle thread
through the hole of the foot.
Place the project under the foot, and lower the needle
at the starting point of the buttonhole mark.
Then lower the automatic buttonhole foot R.
2 Buttonhole mark
3 Needle thread under the foot
4 Bobbin thread under the fabric
5 Starting point of buttonhole
NOTE
Make sure there is no gap between the slider and spring
holder when the buttonhole foot is lowered, otherwise the
left and right sides of the buttonhole will be different.
6 Slider
7 Spring holder
8 Sewing gap
9 Different length
1
2
2
3
7
5
4
6
8
9
3
4