SINGER S18 STUDIO Instruction Manual - Manual (Page 46)

46
Step 5
Start the machine to sew the buttonhole.
The buttonhole will be automatically sewn.
Step 1: The machine will sew the front bartack and the left
row first.
Then it stitches back to the starting point with a
straight stitch.
Step 2: The machine will now sew the right row.
Step 3: The machine will sew the back bartack, and the
machine will stop automatically.
To sew another buttonhole, press the thread cutter button
and raise the presser foot. Reposition fabric to the next
buttonhole mark. Lower needle into starting point. Lower
the presser foot and sew an identical buttonhole as the
first.
Auto thread cutter
If you press the auto thread cutter button after
selecting a buttonhole, the LED signal will turn on.
The machine will stop automatically and trim the threads
when the buttonhole is completed.
Step 6
When buttonhole sewing is finished, push the
buttonhole lever upward as far as it will go.
Step 7
Remove the fabric and place a pin just below the
bartack at each end to prevent accidentally cutting
stitches. Cut the opening with the seam ripper.
Use an eyelet puncher to open a keyhole buttonhole.
9 Seam ripper
10 Eyelet punch
Step 1
Step 2 Step 3
5
6
7
9
10
LED Signal