SINGER S18 STUDIO Instruction Manual - Manual (Page 7)

7
GETTING READY TO SEW
Connecting the Power Supply
Check that power switch is in the off position.
Insert the foot control plug into the machine socket.
Insert the machine plug into the machine socket.
Insert the power supply plug into the wall outlet.
Turn on the power switch.
1 Power switch
2 Foot control plug
3 Machine socket
4 Machine plug
5 Power supply plug
6 Wall outlet
NOTE
If you turn off the power switch, wait for 15 seconds
before turning it on again.
For Your Safety:
While in operation, always keep your eyes on the
sewing area. Keep your hands free from any moving
parts such as the thread take-up lever, handwheel or
needle. Always turn off the power switch and unplug
from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control when not
in use.
1
4
3
2
3
6
5
Controlling Sewing Speed
Speed control lever
You can limit the maximum sewing speed by the speed
control lever according to your sewing needs.
To increase sewing speed, slide the lever to the right.
To decrease sewing speed, slide the lever to the left.
Foot control
Sewing speed is varied by the foot control and the
speed control lever. The heavier the foot presses
down on the controller the faster the machine runs.
The machine runs at the maximum speed set by the
speed control slider when the foot control is being
fully depressed.
Operating Instructions:
The symbol “O” of a switch indicates the “off” position of a switch.
For appliances with a polarized plug (one blade wider than the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If it does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do not modify the plug in any way.