SINGER XL-400 FUTURA Instruction Manual - Manual (Page 78)

76
Reverse stitch button
Forward stitch button
Interupteur couture avancé
Interruptor de puntadas
hacia adelante
Interrupteur couture arrière
Interruptor de puntadas
hacia atrás
Interrupteur marche/arrêt
(Pour la broderie seulement)
Pulsador de comienzo/parada
(Sólo para bordado)
Start/stop button
(For embroidery only)
LED indicator
Témoin a diode
Indicador LED

OPERATION SWITCHES WHEN
EMBROIDERY UNIT IS ATTACHED
OPERATION SWITCHES
LED INDICATOR

Green light indicates machine is ready to start.
 Red light indicates machine is operating.
 Flashing red light indicates a problem or an error.
* Flashing for 2 - 3 seconds shows that an incorrect
operation was made.
* Continuous flashing indicates that the machine
malfunctions.
When start/stop button is pushed, machines starts slowly. To
stop the machine, push the button again and the machine will
stop sewing and the needle stops at its highest position.
FORWARD STITCH BUTTON
After the embroidery design has been transferred to the
machine, the embroidery can be advanced one stitch at a
time. Note: The embroidery hoop will move as it is advancing
through the design.
To advance continuously, press and hold this button.
REVERSE STITCH BUTTON
To back up through a design that is already in progress,
press the Reverse Stitch button. Pressing the button once will
reverse one stitch at a time. To reverse continuously, press
and hold this button. Design may be reversed all the way back
to the first stitch of the design.
START/STOP BUTTON
THREAD TENSION CONTROL
Set it at “ E” for embroidery to loosen thread tension.
You may wish to re-adjust thread tension according to the type
of fabric and thread being used.
NOTE: When sewing designs created by the software for
Photo Stitch (optional) it is recommended to decrease
the thread tension toward “0” and activate the “Speed
limiter”, by checking the box in Machine navigator, before
sending the design to the machine. This ensures the best
performance of the machine.