Ps-1 supply, Router, Monitors – Vinten Radamec AutoCam Multicontroller II User Manual
Page 44: Monitors –10
MultiController II
Installation
3-10
User Manual
4.
Connect power/data cables from the outputs on the power supply (7 pin
Lemo connector) to the respective pan/tilt heads (from 1 to 4 heads).
PS-1 Supply
Do not use the individual control connectors (CAM 1 through CAM 6) if that
camera is being controlled via the CAM HEAD CTRL A or CAM HEAD CTRL
B connectors.
1.
Connect a data cable (9 pin D connectors) from the CAM 1 connector on
the MultiController II to the data input connector on the first PS-1 power
supply.
2.
Connect a power/data cable from the power supply output to the pan/tilt
head.
3.
Repeat steps 1 and 2 for the remaining cameras.
Router
1.
Connect the video output of each camera to its respective input on the
video router.
2.
Connect the router control cable (9 pin D connectors) from the RS-232C
connector on the MultiController II to the control input connector on the
router.
3.
Connect the output of the video router to the operator’s video monitor.
Monitors
1.
If you are using separate monitors for each camera, connect the video out-
put of each camera to its respective monitor.
Router Control