Head type cofiguration, Proportional/fixed speed, Hs-102 – Vinten Radamec AutoCam Multicontroller II User Manual
Page 50: Hs-105, Hs-2010, Head type cofiguration –16, Hs-102 3–16 hs-105 3–16 hs-2010 3–16
MultiController II
Installation
3-16
User Manual
Head Type Cofiguration
The following table lists the configuration choices available:
Proportional/Fixed Speed
In Proportional mode, the pan and tilt speed in response to joystick motion is
dependent on the current zoom angle. Therefore, when you are zoomed in tight,
pan and tilt move more slowly thatn when you are zoomed out wide. Choose the
mode that you feel most comfortable with and set all heads the same.
HS-102
Two baud rate choices (2,400 and 19,200) are provided for the HS-102. Make
sure that you select the baud rate that matches the setting in the head itself. Refer
to the HS-102 User Manual for information on setting the baud rate in the head.
HS-105
Two baud rate choices (2,400 and 9,600) are provided for the HS-105. The nor-
mal selection for the HS-105 is 2,400 baud unless you have a custom version of
the head. Contact your Vinten representative if you are uncertain.
HS-2010
Use the HS-2010 selection if you are using either the HS-2010MH head or the
HS-2010R head.
Config Code
Head Types
Baud Rate
Pan/Tilt Speed
00
HS-105, HS-102
2,400
Proportional
01
HS-2010
9,600
Proportional
02
HS-105 (custom)
9,600
Proportional
03
HS-102
19,200
Proportional
16
HS-105, HS-102
2,400
Fixed
17
HS-2010
9,600
Fixed
18
HS-105 (custom)
9,600
Fixed
19
HS-102
19,200
Fixed