Vinten Radamec AutoCam Multicontroller II - Manual (Page 48)

MultiController II Installation
3-14 User Manual
Powering And Configuring The System
All configuration codes, range limits and other settings are stored in non volatile
memory and are therefore retained when power is off.
Powering Up
The Power On/Off switch is recessed to prevent accidental operation. Push the
switch Up to turn the controller On. Push the switch Down to turn the controller
Off.
Power Up Sequence
Electrically, it does not matter whether you power up the controller first or the
heads. However, if possible, it is usually better to power up the controller first
and then the heads. This will ensure that the heads always receive “clean” data.
If the heads are powered up first, be aware that they may move suddenly as the
controller powers up and initializes.
Recessed ALT Control Switch Power (Mains) On/Off Switch