Tilt limits – Vinten Radamec AutoCam Multicontroller II User Manual
Page 53
MultiController II
Installation
User Manual
3-19
4.
Press and release the left hand recessed Range Limit button. The new range
limit setting is saved and the left hand Range Limit LED will be on to indi-
cate that the head is at the new pan limit.
5.
Press and release the right hand recessed Range Limit button. The right
hand Range Limit LED will be flashing to indicate that the limit is wide
open.
6.
Push the joystick to the right until you reach the desired limit position (The
head may be panning left or right depending on the setting of P/T Reverse).
7.
Press and release the right hand recessed Range Limit button. The new
range limit setting is saved and the right hand Range Limit LED will be on
to indicate that the head is at the new pan limit.
Tilt Limits
1.
Select the head (CAM 1 through CAM 6) that you want to set the limits on.
Before tilting the head, make sure that nobody will be hit by any part of the
head or payload. Make sure that you can see the head as it moves, or have
an assistant watch the head and tell you when to stop to prevent a collision.
2.
Use the tip of a pencil (or a similar non-metallic instrument) to press and
release the upper recessed Range Limit button. The upper Range Limit
LED will be flashing to indicate that the limit is wide open.
3.
Push the joystick up until you reach the desired limit position (The head
may be tilting up or down depending on the setting of P/T Reverse).
4.
Press and release the upper recessed Range Limit button. The new range
limit setting is saved and the upper Range Limit LED will be on to indicate
that the head is at the new tilt limit.
5.
Press and release the lower recessed Range Limit button. The lower Range
Limit LED will be flashing to indicate that the limit is wide open.
6.
Push the joystick down until you reach the desired limit position (The head
may be tilting up or down depending on the setting of P/T Reverse).
7.
Press and release the lower recessed Range Limit button. The new range
limit setting is saved and the lower Range Limit LED will be on to indicate
that the head is at the new tilt limit.