Vinten Radamec AutoCam Multicontroller II - Manual (Page 51)

MultiController II Installation
User Manual 3-17
Configuring The Controller
When you perform the configuration, the controller reads all of the display val-
ues and configures each head simultaneously. You must configure all of the
heads at the same time. You cannot configure heads individually.
1. Select CAM1.
2. Use the numeric keypad to enter the two digit Config. Code for the head
that is installed on CAM 1.
3. Repeat these steps for the remaining heads that are installed in your system.
4. Verify that the two digit configuration code displayed for each camera is
correct.
5. Use the tip of a pencil (or a similar non-metallic instrument) to press and
hold the recessed ALT button while pressing 1 on the numeric keypad.