Vinten Radamec AutoCam Multicontroller II - Manual (Page 54)

MultiController II Installation
3-20 User Manual
Joystick Setup
When the joystick is mechanically centered (i.e. not being touched), the head’s
pan and tilt axes should be stationary. If there is any “creeping” of pan or tilt,
you should center the joystick. In addition, depending on how you like the joy-
stick to feel, you can adjust the speed and deadband.
Joystick Centering
1. With the joystick centered mechanically (i.e. not being touched), press and
hold the SHIFT button while pressing and releasing the 0/CAL button.
Joystick Speed
1. Press CAM 1.
2. Use the numeric keypad to enter a value of 01, 02, 03 or 04 in the CAM 1
display window. A value of 04 is the slowest, 01 is the fastest and 02 is the
factory default.
3. Use the tip of a pencil (or a similar non-metallic instrument) to press and
hold the recessed ALT button while pressing 4 on the numeric keypad. The
new setting for Joystick Speed is now stored in non-volatile memory.
Joystick Deadband
1. Press CAM 1.
2. Use the numeric keypad to enter a value from 01 to 09 in the CAM 1 dis-
play window. A value of 01 is the smallest deadband, 09 is the widest and
03 is the factory default.
3. Use the tip of a pencil (or a similar non-metallic instrument) to press and
hold the recessed ALT button while pressing 2 on the numeric keypad. The
new setting for Joystick Speed is now stored in non-volatile memory.
The system is now ready for operation - refer to Chapter 2.