Bradford White EF-100T-399-3X - Manual (Page 23)

Accessing Service Mode on Control Display
For models with Honeywell Integrated Control
7. Software Version (Display only)
8. Error Code History (Displays if there are present error codes or up to 10 previous error codes). Water Heater
Display will show a “--“ if there are no error codes.
SELECT SET
Status
idle
Operational
To change the Maximum Setpoint Limit (Max Setpoint) for the temperature setpoint:
Step 1: In service mode press the “Select” button until “Max Setpoint” is displayed.
WARNING
Setting the water temperature
to the maximum set point can
result in scalding hot water
delivered to the faucets. It is
highly recommended that the
maximum setpoint be adjusted
to the lowest temperature
possible for the needs of the
installation. Make sure the
water heater control display is
not in a public area that can
result in the temperature
settings being improperly
adjusted.
23
SELECT SET
Status
idle
Operational
Soft
&
SELECT SET
Status
°F
idle
Max
Operational
Setpoint
&
23