MK Diamond MK-101 Lowes - Manual (Page 23)

23
MK-101 OPeRaTiON
PORTaBle GeNeRaTOR
If using a portable generator to provide power, ensure the generator meets the following minimum
requirements: 8Kw 120 Volts 20 Amps Single Phase
(A)
Ensure the ON/OFF Switch is
in the OFF position
(B)
Plug MK-101 into GFCI
(C)
Plug the GFCI into the power
source
SeT CUTTiNG DePTH
When loosing the Cutting Head Adjusting Knob, the Cutting Head will pivot
down unless held.
(A)
Loosen Cutting Head Tri-
Knob and move cutting
head down
(B)
Set cutting depth approxi-
mately 1/4 to 1/2 inch below
the surface of the Movable
Cutting Table
(C)
Ensure the Cutting Head Tri-
Knob is tight
CaUTiON