MK Diamond MK-101 Lowes - Manual (Page 25)

25
MK-101 OPeRaTiON
(D)
Perform the cut. Turn the motor
OFF when work is complete
45° MiTeR CUTTiNG
DO NOT FORCe THe TOOl. It will do the job better and safer at the rate for
which it was designed.
CaUTiON
(A)
Position the 45° Bullnose
Miter Guide and tighten the
retaining thumbscrews
(B)
Position the tile on the 45°
Bullnose Miter Guide and the
Ruler/Stop
(C)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to in-
crease/decrease flow)
(D)
Perform the cut. Turn the motor
OFF when work is complete