MK Diamond MK-101 Lowes - Manual (Page 27)

27
aDJUSTiNG THe CUTTiNG HeaD
The Cutting Head is heavy. Care must be used when changing the position of the
Cutting Head.
CaUTiON
(A)
Remove the blade. Support the
Cutting Head and then remove
Adjusting Knob.
(B)
Remove the Cutting Head from
the rear pivot hole
(D)
Install the Cutting Head onto
the front pivot hole
(C)
Move Cutting Head Stop to down
position
(E)
Install the Adjusting Knob
MK-101 aDJUSTMeNT
For small tiles (6" tile or smaller) the Cutting
Head should be in the rear pivot hole and the
Post should be in the forward post retaining hole.
For large tiles and maximum cutting length, the
Cutting Head should be in the front pivot hole and
the Post should be in the rear post retaining hole.
NOTe:
For maximum cutting length,
the Cutting Head should be
in the front pivot hole and the
Post should be in the rear post
retaining hole.
Move Cutting Head Stop in upward positions
when using rear pivot hole and in the down
position when using front pivot hole.
NOTe:
(F)
Install Diamond Blade. Set
cutting depth approx. 1/4 to 1/2
inch below the surface of the
Movable Cutting Table