MK Diamond MK-101 Lowes - Manual (Page 26)

26
OFF-aNGle CUTTiNG
DO NOT FORCe THe TOOl. It will do the job better and safer at the rate for
which it was designed.
CaUTiON
(A)
Place the 90° Protractor on
the Ruler/Stop and tighten the
retaining thumbscrew
(B)
Set the desired angle and
tighten the thumbscrew
(C)
Position the tile against the 90°
Protractor and the Ruler/Stop.
Turn the motor ON
(D)
Verify proper cooling flow on both
sides of the blade (See Mainte-
nance Section to increase/de-
crease flow)
(E)
Perform the cut. Turn the motor
OFF when work is complete
MK-101 aDJUSTMeNT
To cut angles other than 45° angles or Miter, a 90° Protractor (MK Diamond Part No.
134569-MK) should be used.
NOTe: