Mk-2000 gas saw assembly – MK Diamond MK-2000 Gas Saws User Manual
Page 16
Advertising
16
MK-2000 GAS SAW
ASSEMBLY
STAND (Optional)
(A)
Open the stand and place
it on flat surface.
If using the MK Diamond Stand (Part# 153331), follow these steps.
(B)
Set saw on stand as shown.
(C)
Ensure pins are placed
through holes on frame
NOTE:
MOVABLE CUTTING TABLE INSTALLATION
(A)
While holding the front, position
movable Cutting Table roller wheels
above Guide Rails
(B)
Seat movable Cutting Table roller
wheels on saw Guide Rails
(C)
Verify movable Cutting Table is
seated correctly by moving table
back and forth.
Advertising