MK Diamond MK-2000 Gas Saws - Manual (Page 32)

32
MK-2000 GAS SAW MAINTENANCE
(H)
Move the Throttle Lever to lower
blade speed. Refer to
Engine Manual. turn OFF saw.
DIAMOND BLADE CHANGE-OUT
(A)
Raise Cutting Head and remove
Retaining Screw and Outer Flange.
(B)
Remove old Diamond Blade.
(C)
Install new Diamond Blade onto
Blade Shaft.
(D)
Verify Blade is seated on Blade
Shaft in correct rotation direction.
(E)
Install Retaining Screw and
Outer Flange then tighten.
When installing the diamond blade retaining-bolt, ensure the threads of the bolt
are aligned with the threads of the drive shaft so as not to “cross-thread” the bolt.
NOTE: