MK Diamond MK-2000 Gas Saws - Manual (Page 27)

27
MK-2000 GAS SAW SHUTDOWN
EMERGENCY ENGINE SHUTDOWN
(A)
Place Engine Switch in the
OFF position.
(B)
Move the Throttle Level to lower
blade speed. Refer to your spe-
cific Engine Manual.
(C)
Place Fuel Valve in the OFF
position.
Refer to engine manual for proper engine operation of your specific saw. NOTE:
Engine parts are extremely hot following use, allow engine to cool 1/2-hour
before cleaning. Use care during cleanup to avoid injury.
If a clean external water source was used, steps A to C may be skipped.
CLEANUP
CAUTION
NOTE:
(A)
Clean Water Pump suction of
all debris.
(B)
Place Water Pump in a container of
clean water. Run MK-2000 Gas Saw
until clear water is seen at blade
cooling ports (Approx. 1 minute).
1. To extend operating life, the MK-2000 Gas Saw should be cleaned following every use.
2. Using a garden hose or pressure washer can force water into the air cleaner or muffler opening.
3. Use care when cleaning around electrical components.
(C)
Place Engine Switch in the
OFF position. turn OFF saw.
Refer to Engine manual for
complete shut down procedure.