MK Diamond MK-2000 Gas Saws - Manual (Page 28)

28
MK-2000 GAS SAW CLEANUP
(D)
Clean Water Basin and Mov-
able Cutting table Guide Rails
with soap and clean water.
(E)
Clean Movable Cutting table
Roller Wheels.
(F)
Clean exterior surface of MK-2000
Gas Saw (except engine) with soap
and clean water.
(G)
Clean Air Filter and other engine
parts. Refer to Engine Manual for
your specific engine.
MAINTENANCE
Engine
Periodic maintenance including cleaning, lubrication, tensioning of drive belts, and inspection for wear
and damage are routine servicing procedures. these procedures can prevent serious damage or mal-
functioning of the machine and aid in preserving the useful life of saw blades.
Definitive information on engine maintenance is contained in the engine manual provided separately.
Perform all maintenance procedures as recommended by the engine manual.
WARNING
Shut off the engine before performing any maintenance. If the engine must be run
after a maintenance operation make sure the area is well ventilated. the exhaust
contains poisonous carbon monoxide gas! Exposure can cause loss of conscious-
ness and may result in death.