Wilbur Curtis TL-ILGD - Manual (Page 3)

CONTENTS
AND
UNPACKING
SHIPPING CARTON CONTENTS & UNPACKING
UNPACKING
All products manufactured by the Wilbur Curtis Company are thoroughly inspected at the factory, and are
warrantied to be free of all defects and faulty workmanship. Each grinder is packaged for maximum protec-
tion during shipping. Make sure the shipping carton is not damaged or punctured. Unpack the carton care-
fully, inspecting the contents for any damage that may have occurred in transit.
3
Quantity
TL-ILGD ILGD Part No. Item
ILGD
TL-ILGD
F-3117
Dual Hopper Digital InterLock Coffee Grinder
Dual Hopper Digital ThermoLogic Coffee Grinder
Service Manual
1
1
1
1
SETUP STEPS
1. Read this manual before attempting to operate the coffee grinder.
2. Unpack the carton contents carefully. Inspect the container at time of delivery, for visual or concealed
damage. The carrier must be notified immediately in case of punctured or damaged cartons.
3. This grinder uses a standard electrical outlet of 120VAC, rated at 15 amps.
4. Install the grinder on a level surface.
5. Test the unit by running some whole bean coffee through the grinder. If any problems are encountered,
refer to the troubleshooting section of this manual.
GRINDER REQUIREMENTS
• Electrical
See attached schematic for your model
QUICK START
& SET-UP
OPERATING
INSTRUCTIONS
6. Transfer the filled brewcone to the brewer and begin brewing.
3. Insert the brewcone into the basket holder arms on the grinder.
4. Press the appropriate grind switch.
5. Allow the grind motor to completely stop before removing the brewcone.
1. Open the door on top of the grinder and fill with fresh whole bean coffee.
Close the top door.
2. Place a new coffee filter into a clean brewcone.